Understanding The Silhouetted Images Of The Twin Towers.

WTC 1

Below on the left is WTC 1 at sunrise. The view is not looking down the hallways, we look nearly along the long axis of the towers core. The vertical line of light in the lower segment is created by sunlight reflecting off the inner core walls then shining out the core hallway.

This was the north tower hallway layout, more or less, upper floors were different. The hallway scheme below went up to the 43rd floor for maximum strength.

Below, the North Tower had a core oriented east and west. This image is looking east at sunrise.. The camera perspective is not aligned with the hallway as can be seen by the orientation of the south towers roof indicating an oblique view. The light is reflected off the inner south shear wall at a hallway level where there is no doorway interrupting. Notice the very slight interruptions, dark streaks, whole dark floors. The nature of light under these conditions is to blend, blur and obscure solid areas between the light.

We see no light on the left side because the doorways on the north face do not align with the doors on the east face as they are on a different floor so no direct light and no reflective surfaces are at the proper angle. Above that, or the top sky lobby floor, the top floors had a different scheme with halls on one floor crossing in both directions allowing direct light

Below, annotations identify visible features of the above photo.

.

WTC 2 Silhouetted

The core of the south tower above (on right) is oriented north south with its long axis and had 2 halls crossing the short axis. We see no light through it because the doors on our face only reveal a shadowed inner concrete wall corner. See the 2 vertical, central lines in the image below.

Below: Tower on right, the north tower.

The interior box columns followed the slight taper of the concrete core to a point then had to continue vertically plumb to the roof as the interior wall of the outside tube of the steel framework. (See the spire location page) The purpose of this section and photo is to show the space between the interior box columns and the tapering core face at the upper floors. The north tower had hallways crossing perpendicularly every other floor (diagram below). This picture of the towers is looking due south through the towers.

NOTE: WTC 2 had 3 concrete walls crossing the short axis. One at each end and one in the middle.

Note the tapering vertical space between the interior box columns and the core face on WTC 1.

Above: The north tower (right) core was oriented east west, so we are looking at the wide side. We see, from right to left; a light space from the out side to a dark column which represents the floor space to the interior box column, then there is another narrow light space left of that. That is the space between the interior box column and the concrete core face. Going leftward we see the facing concrete shear wall, dark, then the hallway crossing the narrow axis, then the core face again, then the space between the east core face and interior box column, then floor space to the east side of the building.

I believe the below image is WTC 2 from the north side. There was not enough of the surroundings in the original image to be certain of this The narrow blue lines indicate each side of the hallway openings and the thick lines the entire opening on the west wide side core face.

See the rough sketch of the WTC 2 concrete core structure for another view that shows how the above photo works.

Back To The Scenario

The FEMA Deception
The Psyops, Disinfo & Misinformation
The Twin Towers Design & Construction
The Demolition

Feedback to; argus1@earthlink.net